Pilot-RC BAE Hawk 1.8m (70.9in) Composite Jet

  Click On Images to Enlarge

Overview

Everyone has a soft spot for the BAE Hawk, and this feeling will only develop further once you feel the gentle and smooth yet agile capabilities of our Pilot-RC version.

Specifications

Model:	BAE Hawk
Wingspan:	60.2in (1,530mm)
Length:	70.9in (1,800mm) – without pitot tube
Weight:	17.8lbs (8.05kg)

Features

• Full composite construction, lightweight and strong
• Two piece wing and two piece full flying stabiliser, both fully removable
• Painted outside the mold so no seam lines

Included Hardware

• Complete air frame (including fibreglass control horns)
• Carbon fibre wing-tubes
• Servo extension leads
• Pilot-RC electric retracts and electric brakes
• Dual wall tail pipe (for 60-100N turbines)
• Fuel tank (2000ml) and UAT (250ml)
• Pre-prepared pushrods with ball links
• Pre-glued control horns
• Pilot-RC electric landing gear and brake set

Required Hardware:

Turbine: 60-100N

Servos: Total x8 servos

x1 standard size high torque (important: minimum 28kg)

x1 for elevator

x5 medium size servo (size: 35x15x30mm)

x2 for aileron (minimum 10kg)

x2 for flaps (minimum 10kg)

x1 for rudder (minimum 20kg)

The above five servos slots are also easily adaptable to fit standard size servo if preferred.

x2 medium size servo (size: 35x15x30mm, minimum 10kg)

x1 for steering

x1 for nose gear door

Also requires all the usual accessories such as transmitter, receiver, batteries, powerbox and possibly other small accessories.

Recommended Hardware

Servos:

• 5 x MacGregor MG5921HV 20.3Kg.cm/0.12s High Voltage Digital Servo
• 2 x MacGregor MG2810HV 10.0Kg/0.07s High Voltage Digital Servo
• 1 x MacGregor MGB6928HV 28Kg/0.06s HV Brushless Digital Servo

Servo arms:

• Pilot-RC 1.2in Aluminium arms (PIL556)
• Pilot-RC 0.8in Aluminium arms for Elevator (PIL741)

Video

Presenting the brand new Pilot-RC 1.8m BAE Hawk

Basic Setup

Control throws:

Aileron: 12mm up / 12mm down – 40% Exp (Measured from the wingtip)

Rudder: 38mm left / 38mm right – 50% Expo

Elevator: 20mm up / 20mm down – 45% Expo (Measured from the trailing edge of the elevator at the fuselage.)

Elevator center:

Set the trailing edge of the elevator, 17mm below the top of the fuselage.

Take-off flap: 20mm

Landing flap: 41mm

Measured from the root of the wing (fuselage)

The CG is 125mm from the front leading edge on the root of the wing

Manuals/Downloads

• Coming Soon....